Home | Other Holidays | Friendship Day
O-rings in dripping faucets are typically the source of your leak. Even though they can be responsible for that never ending late-night drip, replacing O-rings in a faucet is a reasonably easy task that can provide folk with a good night's sleep in a matter of minutes. You simply need one tool! This article is going to show you the easy way to replace worn O-rings in a faucet. You don't need to pay a o-ring suppliers to finish this basic task. Make sure your tap is all of the way off. You may either shut the water supply to the faucet or simply turn the tap to the "off" position if the leak is not that bad. Locate the head of your tap, which is the part that unscrews. Take your crescent wrench, attach to the head, and slowly but strongly loosen the head. Remember the "righty tighty, lefty loosy" rule or you may find yourself with a broken faucet head. Once the head is loosened, unscrew it by hand to stop any thread damage. remove the O-ring. If it isn't laying in the head of the faucet, it is attached to the faucet itself right where the head and faucet meet. Replace the old O-ring with your new one. Ensure the O-ring is laying flat and in place . Hand screw the head back onto the tap. Make sure the O-ring is not in the way of the threads or you'll be repeating this process again. Once the head is all the way screwed on, use the crescent wrench to resolutely tighten the head. Again, be careful not to turn too hard! Turn your water supply back on for ten seconds and back off. Wipe the head and watch for one minute to work out if there are any more leaks. If there are no leakages, congratulations! You have successfully replaced your O-ring.
Article Source: http://www.holidaysoftheyear.com
The contributor to this passage is a factory manager of a company dealing with o-ring suppliers production and related manufacturing.
Please Rate this Article
5 out of 54 out of 53 out of 52 out of 51 out of 5
Not yet Rated
